how buttons turn into personalized bracelet

Do you love personalized jewelry?You can make an personalized bracelet with buttons to stand out among the crowd. This method is easy enough for children that are eight and older.
First of all, you have to measure the size of your wrist with a dressmaker measuring tape or piece of string. On the basis of your measurement, add one half inch to the measurement and write this number down for reference.
Now you can start to work by cutting two pieces of the elastic thread to the measurement you have recorded. And arrange some buttons in your design. Tie a knot in one end of each of the two elastic thread pieces. Begin to string buttons by picking up one button and turn it back side up. Insert the end of one of the pieces of elastic thread completely through a hole leaving the knot flush against the back. Repeat with the adjoining hole on the opposite side of the button. Turn the button right side up. Insert one thread down through the button hole on the same side of the button. Repeat these procedures. At this moment, you should see two small straight lines at center of the holes. Go on threading buttons.
At last, test by wrapping the buttons around the wrist to make sure there are enough on the bracelet. Tie a knot in each thread and then tie the two knotted threads together tightly. Do not forget to trim away the excess threads. Adjust the buttons to straighten the bracelet for wear.
The bracelet can be made quite quickly. Now it’s time to wear the button personalized bracelet to show.